Our Story

One piece. Two faces. Zero joints.

Zauber Woodworks pioneered one-piece HDF cabinet door manufacturing — a way to get the exact look of a traditional five-piece door without building it from five pieces. Everything we cut still starts in Danbury, Connecticut.

Danbury, CT 12,000 sq ft Shop CNC-Cut One-Piece HDF
The Problem We Set Out to Solve

Why five pieces, when one will do?

A traditional cabinet door is built from five separate pieces — two rails, two stiles, and a center panel — joined together to create that familiar recessed-panel look on the face of the door. It's a proven design. It's also five pieces, four joints, and four places where wood movement, humidity, or a hard-closing hinge can eventually open a seam and show through paint.

We asked: what if the door were routed, not assembled?

Zauber pioneered a matched pair of custom CNC programs — one that routes the front face, one that routes the back — cutting in register with each other on a single solid blank of HDF. The result is a door with a front recessed panel and a back recessed panel that mirror a traditional five-piece profile, with no rail, no stile, and no joint to open up down the road.

What This Means For You

Same look, one continuous piece.

Because both faces are programmed together, the panel detail lines up front-to-back the way it would on a built-up door — but there's no glue line to telegraph through paint, no joint to loosen over time, and no piece-to-piece variation between the door you order today and the one you reorder next year.

It's the same reason our doors run identically batch after batch: the program doesn't drift the way hand-assembly can. Whatever profile you spec, the tenth door looks exactly like the first.

In Cross-Section

Same profile, one less part.

A simplified edge view of a rail meeting a panel — traditional construction on the left, Zauber's one-piece HDF on the right.

Traditional 5-Piece

2 Rails · 2 Stiles · 1 Panel

5 separate pieces · 4 mitered joints 1 TOP RAIL 2 BOTTOM RAIL 3 LEFT STILE 4 RIGHT STILE 5 PANEL

Five separate pieces — two rails, two stiles, and a panel — cut on their own and joined at four mitered corners. Every joint is a future seam.

Zauber One-Piece HDF

One Continuous Blank

1 piece · 0 joint lines · profile front & back FRONT PASS BACK PASS

Two synchronized CNC programs route the front and back of a single HDF blank so the recessed panel matches on both faces — no rail, no stile, no joint.

Where It Fits

Built for whatever's next in your pipeline.

The same one-piece construction works across project types — the sizing and profile change, the process doesn't.

New Construction

Full kitchen and bath door sets, matched and sized to the cabinet run.

Remodels & Refacing

Replace what's there without touching the boxes — sized to your exact opening.

Spec & Production Builds

Repeatable profiles that match run after run, order after order.

Custom & One-Off

A single replacement door or a custom profile — no minimum quantity; orders under $175 are billed at the $175 minimum.

See the profiles for yourself.

Browse every one-piece profile we cut, or send us your sizes to get started.